Promise Technology VTrack M-Class M500p Manuel télécharger pdf (Page 296)

VTrak M-Class Product Manual

288

Network Connections

VTrak has an RJ-45 Management Port connector on the back of its cabinet. This

is a Gigabit Ethernet connector designed to connect to your network. The VTrak

becomes a node on your network like any other PC, server or other component

with an IP address.

VTrak ships from the factory an IP address of 10.0.0.1. You must change this

address to one that will work with your network. You make the initial IP address

setting using the CLI or CLU. See “VTrak Setup with CLI or CLU” on page 29.

Note that VTrak Management Port can accept IP address assignments from a

DHCP server. Use VTrak's Command Line Utility (CLU) to enable this feature. If

you have not activated DHCP support but there is a DHCP server on your

network, there is a chance that it will inadvertently assign the VTrak's

Management Port IP address to another node. You might see a warning to this

effect on your PC's monitor. If this happens, WebPAM PROe may not be able to

connect. See your network administrator to work out a suitable arrangement.

LEDs

State

Dark Amber Green Flashing Green

Connectivity 10BaseT 1000BaseT 100BaseT n/a

Activity No activity n/a n/a Activity

“n/a” means this state does not apply to this LED.

Connectivity LED Activity LED

1 2 ... 291 292 293 294 295 296 297 298 299 300 301 ... 315 316

Pas de commentaire

Promise Technology VTrack M-Class M500p Manuel Page 296