Promise Technology VTrack M-Class M500p Manuel Page 23

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 316
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 22
Chapter 2: Installation
15
Follow this procedure to install the rails:
1. Check the fit of the rails in your rack system.
2. Slide the plates out of the rails.
3. Attach the rail plates to the VTrak housing.
Line-up the rail plates using the studs. Install with six screws each side.
4. Slide the rails over the plates.
5. Attach the sliding flanges to the rails with the adjustment screws provided.
6. Attach the four-hole flange to the inside of the rack’s front post.
7. Attach the two-hole flange to the inside of the rack’s rear post.
8. Repeat steps 6 and 7 to attach the other rail.
9. Square the rails in the rack and tighten the attaching screws (not included).
Cautions
Do not lift or move the VTrak by the handles on the housing,
power supplies or the controller units. Hold the VTrak by the
housing only.
Do not install the VTrak into a rack without rails to support it.
Vue de la page 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 315 316

Commentaires sur ces manuels

Pas de commentaire