Promise Technology FastTrak TX2000 Manuel d'utilisateur télécharger pdf (Page 10)

FastTrak TX2000™ Series User Manual

Installing The Card

Installing the FastTrak TX2000 controller card in a system is a simple process. The card fits into

any available 32-bit PCI slot (must be PCI 2.1 or 2.2 compliant), or the 32-bit portion of a 64-bit

PCI slot, on the system’s motherboard (see figure below).

1. Remove the cover of your system.

2. Remove the inside slot cover of an available 32-bit PCI slot on the motherboard.

3. Install the FastTrak TX2000 controller card into the open slot (see Figure 1 below).

4. Attach your system case’s 2- or 4-pin LED cable to the LED connector on the

FastTrak TX2000 controller card (see Figure 2 on page 8). Make sure that pin 1 on

the connector is aligned with pin 1 of the cable.

5. Fasten the controller card bracket to the system case (see below).

Figure 1

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 69 70

Pas de commentaire

Promise Technology FastTrak TX2000 Manuel d'utilisateur Page 10