Promise Technology SUPERSWAP 1600 Manuel d'utilisateur télécharger pdf (Page 23)

Chapter 2: Installation

4. Insert the key and turn it 90 degrees clockwise to lock the drive carrier in the

enclosure.

Remove a Disk Drive

1. Pull the drive carrier handle out and swing it to the left.

2. Pull the drive carrier out of the SuperSwap enclosure.

3. Remove the screws attaching the disk drive to the drive carrier.

4. Lift the disk drive from the drive carrier.

5. For 2.5-inch disk drives, remove the bracket from the drive.

6. Reinstall the disk drive as described under Install a Disk Drive, above.

Note

The previous generation of SuperSwap enclosures used the key

lock to activate power as well as secure the drive carrier.

SuperSwap 1600 uses the key lock only to secure the drive

carrier. Power is available at all times, in order to comply with

SATA requirements.

Locked

Unlocked

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Pas de commentaire

Promise Technology SUPERSWAP 1600 Manuel d'utilisateur Page 23