Promise Technology FASTtrak100 LP Manuel d'utilisateur télécharger pdf (Page 36)

Rebuilding An Array

This command effectively copies or overwrites data from an existing data drive in the array

on to a blank drive. The operation will be typically used when a failed drive has been

replaced with a new drive in the mirrored array.

1. To perform a Rebuild, click the “Array” tab.

2. Right-click the array number and choose “Rebuild” from the context menu.

3. You will be asked to “Initialize Rebuild process on Array #”. Click “OK”.

Using the Rebuild Wizard

1. Initiating the rebuild array will open the Rebuild Wizard Step 1 screen as shown below.

2. Select the Target drive that will receive data. Make sure you select the new blank or

replacement drive. The unselected drive contains “good” data. It will be the remaining

working drive in an array, or a system drive containing existing data that you would wish

to mirror.

WARNING: You must be absolutely sure of the drive. If data exists on the target

drive, it will be overwritten.

3. Click “Next” to proceed to Rebuild Wizard Step 2 (see next page) or “Cancel” to stop.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 57 58

Pas de commentaire

Promise Technology FASTtrak100 LP Manuel d'utilisateur Page 36